FIREPLUG CDI for Arctic-Cat 80-81 EL TIGRE 5000 & LYNX 2000S SNOWMOBILES


NEW for FALL 2021

This is a rare 2-year only model CDI that has not been made available in aftermarket until now!  Please read the details before ordering to confirm this is a match for replacement


Connectors are OEM bullet terminals, a 2-position plug and a 3-position plug (shown).

*FIREPLUG CDI to replace the 070000-0580 NIPPONDENSO CDI used on the 80/81 Arctic Cat 5000 and also LYNX 2000S (1-cyl 250).

Uses Factory OEM-style connectors & terminals for direct plug-in to factory harness.  No wiring changes necessary.

Bolts down in OEM locaton, plugs into OEM factory connectors

More spark energy over stock OEM CDI! 

NOTE: FIREPLUG CDI housing is similar in size to OEM and will fit in original mounting location (see pic below / 5000 El-Tigre engine))

*Closely follows OEM timing profile for true plug & play installation.

Best WARRANTY available!

Fireplug CDI’s have proven extremely reliable since 1998!

FITS THE FOLLOWING  (please confirm your model matches below & matches the terminal wiring in pictures before ordering)
80/81 EL-TIGRE 5000
LYNX (single cylinder)

This was a rare CDI with limited 2-year production run.  It’s possible it could fit other models not listed. 

Check for stamping on OEM CDI box, then note the type of connectors used for fitment.

STATOR VALUE:  4-pole / 120W lighting

RED/BLACK to BLACK/WHITE = 84-ohms (approx)

BLACK to Engine = 14-ohms (measured) with kill-sw in RUN position.  If Kill-Switch is ON, then BLK to Eng = (open) NC-ignition type / kill-sw

* Always check your timing when changing CDI’s to confirm it is set to factory specifications.

Additional information

Weight 1 lbs